Q: How Do I Remove and Install a Power Steering Pump?A: Disconnect the cable from the negative battery terminal, then disconnect the positive battery cable. Caution: If the stereo in your vehicle is equipped with an anti-theft system, make sure you have the correct activation code before disconnecting the battery. Disconnect the fluid hoses at the pump, noting the difference between the pressure and the return hoses; the return hose is held to the pump with a spring type clamp, and the pressure line has two bolts holding it to the pump body. Cap or plug both hoses to prevent leakage or contamination. Install a new O-ring on the end of the pressure line. Remove the pump adjusting bolt and the pump mounting bolt(s) and remove the pump from the engine. Installation is the reverse of removal. Be sure to adjust the drivebelt tension and bleed the power steering system.