Acura 32600-S0K-A10 Battery Ground Cable Assembly

Periodically inspect the entire length of each battery cable for damage, cracked or burned insulation and corrosion. Poor battery cable connections can cause starting problems and decreased engine performance. Inspect the cable-to-terminal connections at the ends of the cables for cracks, loose wire strands and corrosion. The presence of white, fluffy deposits under the insulation at the cable terminal connection means that the cable is corroded and should be replaced. Also inspect the battery posts for distortion and corrosion. If they're corroded, clean them. When removing the cables, always disconnect the cable from the negative battery terminal first and hook it up last, or you might accidentally short out the battery with the tool you're using to loosen the cable clamps. Even if you're only replacing the cable for the positive terminal, be sure to disconnect the negative cable from the battery first. Disconnect the old cables from the battery, then trace each of them to their opposite ends and disconnect them. Be sure to note the routing of each cable before disconnecting it to ensure correct installation. There are battery positive cables at the engine compartment fuse and relay box, at the starter motor and at the alternator. There are many ground cables in the engine compartment; you'll find them on the walls of the engine compartment, on the engine block and even on the motor mount brackets. Raise the front of the vehicle and place it securely on jackstands, then use a flashlight to trace ground cables to their respective ground bolts. If you are replacing any of the old cables, take them with you when buying new cables. It is vitally important that you replace the cables with identical parts. Clean the threads of the solenoid or ground connection with a wire brush to remove rust and corrosion. Apply a light coat of battery terminal corrosion inhibitor or petroleum jelly to the threads to prevent future corrosion. Attach the cable to the solenoid or ground connection and tighten the mounting nut/bolt securely. Before connecting a new cable to the battery make sure that it reaches the battery post without having to be stretched. Connect the cable to the positive battery terminal first, then connect the ground cables to the negative battery terminal.