To remove the cruise control switch on 1999 through 2003 models, pry it out with a trim panel removal tool or a screwdriver, ensuring to tape the tip for protection, then disconnect the electrical connector. For the fog light or moonroof switch, remove the driver's side lower dashboard cover, reach behind the switch to depress the release tabs, push the switch out, and disconnect the electrical connector. Installation is the reverse of removal, ensuring the switch snaps into place. For 2004 and later models, first remove the driver's side dashboard lower cover. To remove the power mirror control switch, take out the two screws, and for the Vehicle Stability Assist (VSA) OFF switch, depress the release tabs and push it out. Installation follows the reverse process, ensuring the VSA OFF switch snaps into place. For the instrument panel brightness control switch on 1999 through 2003 models, remove the driver's side dashboard lower cover, disconnect the electrical connector, and take out the two mounting screws. For 2004 and later models, remove the instrument cluster trim panel, take out the retaining screws, and remove the switch. The installation is the reverse. For the hazard flasher switch, on 1999 through 2003 models, remove the instrument cluster trim panel, and for 2004 and later models, remove the center upper panel. On 1999 through 2003 models without navigation, remove the two screws securing the switch, while on models with navigation and all 2004 and later models, depress the release tabs and pull the switch out. Installation is the reverse. For the trunk lid release switch, on 1999 through 2003 models, remove the driver's door trim panel, and on 2004 and later models, remove the driver's side dashboard lower cover. Remove the mounting screws and the switch, with installation being the reverse. For the multi-information display switch, remove the instrument cluster trim panel, take out the retaining screws, and remove the switch, with installation being the reverse. For the moonroof switch on 2004 and later models, carefully pry it out and disconnect the electrical connector, ensuring it snaps into place during installation. For seat heater switches, on 1999 through 2003 models, remove the console panel tray, and on 2004 and later models, remove the center console panel. On earlier models, depress the release tabs to pull out the defective switch, while on later models, remove the retaining screws and switch, with installation being the reverse.
Posted by AcuraPartsWarehouse Specialist 
