Acura 60100-SEP-A90ZZ Engine Hood Gray

The hood is heavy and somewhat awkward to remove and install, so at least two people should perform this procedure. Use blankets or pads to cover the fenders and cowl areas to protect the body and paint during removal. Scribe or draw alignment marks around the bolt heads and hood hinges to ensure proper alignment during installation. Disconnect any cables or wire harnesses that may interfere with removal, then unbolt the hood support strut from the hood. With assistance, support the weight of the hood, remove the hinge-to-hood bolts, and lift off the hood while supporting it with your shoulder. Installation is the reverse of removal; position the hood so that the hinges fit within the scribe marks made earlier for proper alignment. If installing a new hood or if the hinge positions were not scribed, readjust the hood position. Adjust the hood's fore-and-aft and right-and-left alignment using the elongated holes in the hinges, scribing a line around the hinge plate to judge movement. Loosen the bolts, make small adjustments, and tighten them while checking alignment. If necessary, adjust the entire hood latch assembly up-and-down and side-to-side on the upper radiator support, scribing a line around the latch mounting bolts for reference before repositioning and retightening. Adjust the vertical height of the leading edge of the hood by turning the edge cushions in or out to ensure it is flush with the fenders when closed. Periodically lubricate the hood latch assembly and hinges with white lithium-base grease to prevent sticking and wear.