Acura 35130-SD4-A01 Switch, Steering

Uncover the steering wheel, and find the ignition switch/key lock harness connection from there to the fuse box. Disconnect the cable here. Look for two way signals (continuity) from the connector while you insert keys into different positions. When the continuity doesn't match what's listed, put the key into Off mode, loosen two screws, lift the switch off the steering column, making sure the notch on the switch lines up with the projection on the lock when you install it. Install the steering column cover. Look at all lock cylinder settings and check that it runs smoothly and correctly matches the key position visibility on the housing, then replace the part if it's damaged or worn. If you own a Legend, first disconnect the ignition key light. Insert a small tool into a notch on the dashboard and push the tool in until you feel the lock cylinder release. Then pull the cylinder out of its housing. Put the key in lock, put the lock cylinder straight, put the key almost to lock, push the cylinder in until it hits the housing, then finish turning the key all the way to lock while pressing and pushing the cylinder till it clicks. Finally, install the steering column cover.