Acura 37840-PGE-A11 Tdc Sensor Assembly

For 2001 and earlier models, the CMP (TDC) sensors are located on the right end of the front cylinder head. Begin by disconnecting the CMP sensor electrical connector by depressing the release button and pulling the upper half of the connector straight up from its mounting bracket. Next, remove the timing belt cover and the timing belt, followed by the sprocket from the camshaft in the front cylinder head. Detach the rear timing belt cover by removing the mounting bolts and then take off the cover. Remove the CMP (TDC) sensor mounting bolts to detach the sensors from the rear timing belt cover and then remove the sensors. Installation follows the reverse order of removal. For 2002 and later models, the CMP sensor is also located at the right end of the front cylinder head. Disconnect the electrical connector from the CMP sensor by depressing the release tab and pulling off the connector. Remove the timing belt cover, the timing belt, and the camshaft sprocket. Detach the rear timing belt cover by removing the mounting bolts and then take off the cover. Remove the CMP sensor mounting bolt to detach the sensor from the rear part of the timing belt cover. Installation is the reverse of removal.

Disconnect the CMP sensor connector by pressing the release button and pulling the connector halves apart. Remove the timing belt cover, belt, and camshaft sprocket from the front cylinder head. Take off the rear timing belt cover and the CMP sensor. To install, reverse the process. For 2003+ Acura and 2005+ Honda models, disconnect the CMP sensor connector, and remove the timing belt cover, belt, and camshaft sprocket. Remove the rear cover and the CMP sensor from the timing belt cover. Installation is the reverse of removal.