How to replace the Headlight Switch, Turn Signal Switch and Wiper Switch on Acura MDX?

To begin the removal process for safety reasons, firstly disconnect the cable from the negative terminal on the battery and wait for at least 3 minutes before proceeding. Next, remove both upper and lower steering column covers including knee bolster. To remove the headlight switch, high beam/low beam switch and turn signal switch which make up multi-function switch, disconnect its electrical connectors from the switch and take out retaining screws. Finally prise apart the little pad on a small lug of a key way by means of careful fingers to get into a position where you can yank it out; after that you will have to pull out this very item which is called "a wiper/washer switch". The procedure for removing a wiper/washer switch involves an electrical connector removal, taking off retaining screws as well as prying away housing from that small pad on top of such device until it finally comes out. In addition to that, steering wheel together with airbag clockspring must be removed in order to access combination switch assembly containing multifunction switches as well as wiper/washer switches. Disconnect all wires from multifunction switches as well as windshield wiper/washer switches and combination switch. Then unclip airbag electrical harness from small bracket located at left side of key lock cylinder/ignition switch housing by pulling clip towards rear of vehicle; also disconnect big yellow connector attached to airbag harness. Remove mounting screws(3)and combination switch assembly from steering column. This is done in reverse order during installation.

Genuine Acura MDX Wiper Switch

Windshield Wiper Switch

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

11 Wiper Switches found

View related parts
Acura MDX Wiper Switch Assembly
Part Number: 35256-TZ5-K61
$56.74 MSRP: $79.13
You Save: $22.39 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Wiper Switch
- Warranty: This genuine part is guaranteed by Acura's factory warranty.
View related parts
Acura MDX Wiper Switch Assembly
Part Number: 35256-TZ5-K51
$55.59 MSRP: $77.53
You Save: $21.94 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Wiper Switch
- Warranty: This genuine part is guaranteed by Acura's factory warranty.
View related parts
Acura MDX Wiper Switch Assembly
Part Number: 35256-STX-A03
$282.89 MSRP: $404.02
You Save: $121.13 (30%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Switch Assembly, Wiper; Wiper Switch
- Warranty: This genuine part is guaranteed by Acura's factory warranty.
View related parts
Acura MDX Wiper Switch Assembly
Part Number: 35256-S3V-A11
$103.77 MSRP: $145.58
You Save: $41.81 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Switch Assembly, Wiper; Wiper Switch
- Warranty: This genuine part is guaranteed by Acura's factory warranty.
View related parts
Acura MDX Touring Windshield Wiper Column Combo Switch
Part Number: 35256-S3V-A02
$103.77 MSRP: $145.58
You Save: $41.81 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Switch Assembly, Wiper; Wiper Switch
- Warranty: This genuine part is guaranteed by Acura's factory warranty.
View related parts
Acura MDX Wiper Switch Assembly
Part Number: 35256-TZ5-K41
$55.59 MSRP: $77.53
You Save: $21.94 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Wiper Switch
- Warranty: This genuine part is guaranteed by Acura's factory warranty.
View related parts
Acura MDX Switch Assembly , Wiper
Part Number: 35256-TYA-L71
$31.40 MSRP: $43.80
You Save: $12.40 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Wiper Switch
- Warranty: This genuine part is guaranteed by Acura's factory warranty.
View related parts
Acura MDX Switch Assembly , Wiper
Part Number: 35256-TJB-D51
$57.52 MSRP: $80.22
You Save: $22.70 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Wiper Switch
- Warranty: This genuine part is guaranteed by Acura's factory warranty.
View related parts
Acura MDX Switch Assembly , Wiper
Part Number: 35256-TYA-L81
$31.40 MSRP: $43.80
You Save: $12.40 (29%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Wiper Switch
- Warranty: This genuine part is guaranteed by Acura's factory warranty.
View related parts
Acura MDX Windshield Wiper Switch
Part Number: 35256-STX-305
$341.72 MSRP: $488.03
You Save: $146.31 (30%)
Product Specifications
- Other Name: Switch Assembly,Wiper; Wiper Switch
- Replaces: 35256-STX-A01
- Warranty: This genuine part is guaranteed by Acura's factory warranty.
View related parts
Acura MDX Windshield Wiper Column Combo Switch
Part Number: 35256-S3V-A01
Product Specifications
- Other Name: Switch Assembly, Wiper; Wiper Switch
- Warranty: This genuine part is guaranteed by Acura's factory warranty.

Acura MDX Wiper Switch

The Acura MDX Wiper Switch allows drivers to have immediate and accurate control of the windshield wipers. This protects clear sight lines during rain, sleet, or swirling road spray. Mounted on the left steering column stalk, the Wiper Switch is applied by the operator to turn the blades on with a simple flick of the wrist, followed by selecting between intermittent pauses, a steady low speed, or rapid high speed, with clicking to off once the glass is shining. Early MDX versions and later editions share the familiar stalk-style Wiper Switch, so muscle memory transfers from one model year to the next. The main difference lies in the addition of a broader intermittent timing band, as is applied on newer Acura sport-utility editions, providing additional detent stops that help fine-tune the sweep intervals while retaining the robust contacts, internal springs, and tactile feedback that are highly characteristic of every Wiper Switch applied throughout the MDX lineup. Regardless of year, each Acura Wiper Switch directs electrical current down dedicated circuits to the wiper motor, providing an instant way to attain the blade speed needed for drizzle or downpour, so the driver may focus on traffic and terrain rather than struggling to see through a blurry windshield.

We provide a broad range of OEM Acura MDX Wiper Switch at unbeatable prices on our website. For your OEM parts, You can count on the guaranteed quality, manufacturer's warranty, outstanding customer service, and prompt delivery. We look forward to your visit.

Acura MDX Wiper Switch Parts Questions & Experts Answers

Touring Windshield Wiper Column Combo Switch
35256-S3V-A02
Q: How to replace the Headlight Switch, Turn Signal Switch and Wiper Switch on Acura MDX?
A:
To begin the removal process for safety reasons, firstly disconnect the cable from the negative terminal on the battery and wait for at least 3 minutes before proceeding. Next, remove both upper and lower steering column covers including knee bolster. To remove the headlight switch, high beam/low beam switch and turn signal switch which make up multi-function switch, disconnect its electrical connectors from the switch and take out retaining screws. Finally prise apart the little pad on a small lug of a key way by means of careful fingers to get into a position where you can yank it out; after that you will have to pull out this very item which is called "a wiper/washer switch". The procedure for removing a wiper/washer switch involves an electrical connector removal, taking off retaining screws as well as prying away housing from that small pad on top of such device until it finally comes out. In addition to that, steering wheel together with airbag clockspring must be removed in order to access combination switch assembly containing multifunction switches as well as wiper/washer switches. Disconnect all wires from multifunction switches as well as windshield wiper/washer switches and combination switch. Then unclip airbag electrical harness from small bracket located at left side of key lock cylinder/ignition switch housing by pulling clip towards rear of vehicle; also disconnect big yellow connector attached to airbag harness. Remove mounting screws(3)and combination switch assembly from steering column. This is done in reverse order during installation.