Rephrase these only if possible. Rephrase verbalization when possible too. Enter through the large gap in the door to detach these five parts: the outside handle-to-latch rod, outside lock-to-latch rod, inside lock-to-latch rod, inside handle-to-latch rod, and lock solenoid-to-latch rod if your car has it. The plastic clips attaching the door locking rods can be undone by pressing the unlocked side and pulling the rod out of the hole. Unscrew the latch to the door, then pull it out completely. To take out the outside handle and lock cylinder parts, lift the window and remove both the
Door Trim Panel and watershield. Going through a small opening, pull out the plastic parts holding the outside handle rod and door lock rod, then remove the handle bolts and take the handle and lock cylinder out when you take it off the car. For manage specific cars, you need to break away the clip keeping the lock cylinder in place and pull out the cylinder from the handle before you disconnect the handle itself. To reach the interior handle on Integra cars, first take off the door trim panel and peel back the watershield. Then take the door actuating rod guide off without force, remove the handle screws, and pull the handle away. Take the handle handle outside of the door, slide it away from the door's actuating rod, and then unpull the whole handle from the door. You can follow the same steps backward to install all parts.