Q: How to check and adjust the Shift Cable?A: Perform a comprehensive check by attempting to start the engine in each shift lever position. The starter should function exclusively in the Park and Neutral positions. If the starter operates in any other position than Park and Neutral or doesn't operate in Park or Neutral, it indicates that the shift cable necessitates adjustment or the Neutral start switch is faulty. To adjust the shift cable, start by removing the center console. Place the shift lever in Drive (Integra) or Reverse (Legend), then extract the lock pin from the adjuster. Verify that the hole in the adjuster aligns perfectly with the hole in the shift cable; these cable holes are positioned 90 degrees apart, enabling adjustment in 1/4-turn increments. If the alignment isn't perfect, loosen the locknut on the adjuster, adjust the adjuster until alignment is achieved, then retighten the locknut and reinstall the lock pin. If the pin binds during installation, redo the cable adjustment. Test engine starting in each shift lever position again, ensuring it only functions in Park and Neutral. If this isn't the case, the Neutral start switch is likely defective, or the shift cable necessitates further readjustment. Conclude by reinstalling the center console.